Updating old file cabinets who is eddie redmayne dating
where I have two identical metal file cabinets that are perfectly functional, but were a bit beat-up and just plain – boring!
I have been wanting to glam them up for sometime with a file cabinet makeover and finally did last week.
As I was on the lookout for more office storage, the file cabinet immediately caught my eye.
See below for a step by step tutorial of how I transformed it! Remove hardware - you can pry off the card holders easily with a screwdriver and unscrew the pulls from the back using a socket. Sand the filing cabinet - be sure to sand down any rusted areas and give the whole cabinet a light sanding to help the paint adhere better. Clean the cabinet well - my cabinet was pretty dirty when I got it.
playroom for boys, Molly’s bedroom (I should say napping room, however, since she actually sleeps in our bed every night), a changing room (and diaper storage) for Charlie, a gathering place for all our mail, paperwork, etc, and last (and probably least), a sewing/crafting room for me. In my vision, this will be an office space with white walls (I love white!!! In my spare time I try to be crafty, and love all things DIY and homemade.
Sand all surfaces to be painted (basically all except drawers, and inside of cabinet). you’ll also want to sand, prime and paint the edges of your drawers (see second picture below). I laid the shelf paper out flat, traced the drawer fronts, and used an X-acto knife to carefully cut the paper. Step 7: Re-Install hardware (if yours was decent to begin with), or install new hardware if it was double ugly (like mine! I'm a busy mom to three little boys and wife to a great guy.
With tons of locations across the US, there is bound to be one near you too!
I also added wheels as I wanted to make them easy to move around the room if I ever rearrange the room – which I tend to do a lot. If the height of the veneer is more than the height of the edge of the board, simply run a knife along the edge to trim the excess veneer or use the handy little edge trimmer. Attach wheels to the bottom board with wood screws. Leave about two inches from the edge of the center of each wheel. Working from the inside of the cabinet -remove the drawers and drill a small hole in the bottom metal so the screw has a place to get into the wood. Place the second cut plywood board on top of the file cabinets. I mixed my DIY chalk paint in a plastic container with a lid.
I have added wheels to a few other pieces of furniture I have made over in the past – the game table in my family room and my crafts cart, that I take with me to load up my supplies when working on a project while I am watching a movie on TV. I marked and pre-drilled each hole to make the process easier. Turn the base board over and put the locking wheel in the “ON” position so the base doesn’t move. I did not attach the file cabinets to the boards – they weigh a lot and are very secure. Screw a wood screw through the hole and into the base wood. Since I loved how the hutch in my dining room came out when I mixed both Plaster of Paris and Calcium Carbonate powder (health food store) into the paint, I decided to do that again. Mix this with 1 – 3 tablespoons of water and mix until smooth.
The store was full of materials salvaged from homes - cabinets, doors, tile, lighting, furniture - you name it.
I was amazed by the variety of materials they carried and their prices are hard to beat.
Search for updating old file cabinets:
They had several of these old file cabinets in various colors and sizes for sale for $50 each.