Windows xp validating identity network i have been dating a girl for 3 months
I am, as you can tell, far from proficient at this. You need to change the routers encryption to just wpa or wpa-psk.
your card does not support wpa2 if i am reading your dropdown list correctly on your card.
(I tried TKIP later, when this didn't work, with the same results as described below.) So I set it to WPA-PSK / AES and entered my security key.
It's mixed letters and numbers, 32 characters long. Still "waiting for reply" in the main screen, and "cannot find certificate" on the pop-up.
Then select "MS Windows 8" as your operating system and download & install the configuration file.) 1. Also select "Microsoft: Protected EAP (PEAP)" as the network authentication method. Check the following checkboxes: After this click "Configure" 8. Check the checkbox "Specify authentication mode" and from the dropdown menu select "User authentication" After this click "OK". Click "OK" once again so the settings are saved and enabled.
Configuring the wireless network begins from the desktop. Select "Manually connect to a wireless network" and click "Next" 4. Check that the following checkbox is NOT checked: "Automatically use my Windows logon name and password" and click "OK" 9. After the settings have been configured, you can connect to the wireless network using the JYU user account password.
Then select "MS Windows 7" as your operating system and download & install the configuration file.) In case the wireless network does not work, you can set the settings manually as instructed below. Configuring the wireless network begins from the desktop. In case you have previously connected to the wireless network by using Secure W2-program, first select jyu-student or jyu-staff from the list and click "Remove". In the "Network name" field type in the wireless network you need: After this click "Configure" 18. In case you are at the JYU campus area, the wireless network will start to connect. Type your JYU username password in to the "User name" "Password" fields. [email protected]) The easiest way to configure eduroam on Windows XP is to download and install a pre-made configuration file from: https://cat.eduroam.org/ (Click the button where it says "eduroam user: download your eduroam installer" and select "University of Jyväskylä" as the organization. Make sure that "Automatically select the certificate store based on the type of certificate" is selected and then click "Next" 6. Select the "Authentication"-tab and from the "EAP type" dropdown menu select "Protected EAP (PEAP)" 15.
I pulled everything out, swapped out the motherboard, and reinstalled Windows on a freshly wiped hard drive, and now I can't get it up and running again. I've taken several runs at it, including attempting to manually change the settings for the network to include WPA-PSK and AES and the password, and I'm a bit worried that I've totally boned everything.And if I try again and return to the settings again, it is reset to Open/AES.It also re-enables 802.1x in the Authentication tab if I've deselected it with WPA-PSK. I have no idea how I blundered into getting this working in the past. from your screen shots what I am seeing is you chose wpa2-only for your encryption on your router and you are setting your ethernet card to wpa-psk.My router settings: ipconfig/all results from the XP box: Again, this card a week ago.I can't figure out why I can't get it up and running now.